Millers Classic Running-In Oil SAE 30

Description

Millers Classic Running-In Oil SAE 30

Millers Classic Running-In Oil SAE 30 for classic and vintage engines.    This product is designed for the initial running in of re-built engines. Use of this product optimizes performance and fuel efficiency.

APPLICATION

Use for initial running in of re-built engines. Formulated for running in on the road. Can be used for test-bed running. Run engine at peak torque to ensure maximum bedding-in of piston rings. Drain and refill with the Millers Classic lubricant most suitable for the engine. Suitable for limited road use (500 miles) after which it should be replaced with the appropriate Millers Classic engine oil.  Note: Do not use high performance oils before the bedding-in process is complete.

USER BENEFITS:

• High quality mineral oil formulated to solve the problems experienced when reconditioned engines do not bed-in.
• Provides full protection to highly stressed valve gear and associated components whilst allowing piston rings to bed in against the bore.
• Suitable for 500 miles after which it should be replaced with the appropriate Millers Oils classic engine oil.
• Good running-in will optimise the performance and fuel efficiency of a reconditioned engine.
• Very low leak down (4%) obtained after thorough running-in process.

PERFORMANCE PROFILE for Millers Classic Running-In Oil SAE 30:

API: SE, CC

TYPICAL CHARACTERISTICS:

SAE Viscosity Grade … 30
Specific Gravity @ 15°C … 0.887
Kinematic Viscosity @ 100°C … 11.9cSt
Kinematic Viscosity @ 40°C … 104cSt
Viscosity Index … 103
Pour Point °C … -15
Flashpoint °C … 220

PRODUCT SIZES:

Millers Classic Running-In Oil SAE 30 is supplied in the following sizes: 1L, 5L, 20L, 60L, 199L.

ADDITIONAL INFORMATION:

For further information on this product, and on other products for competition use, please refer to the FAQs Classic page and our full range of Classic Engine oils available for purchase from our online shop.

For details of our other running in oil, see Millers CRO 10W40 Competition  Running In oil. This product is designed for up to 5 hours test-bed running in but may also be used for light operational duties up to 500 miles/800kms on the road.

For other useful info, see the following articles:

I have just rebuilt my engine, how do I run it in?

How can I protect my rebuilt engine?

HEALTH AND SAFETY:

Health and Safety Data Sheet 7932 applies to this product. When used for the purpose recommended and with due regard to the appropriate Health and Safety Data, the product should cause no concern. If in doubt, consult with Millers Oils Technical Department.