Driveline Flushing Oil

Description

Millers Driveline Flushing Oil

Millers Driveline Flushing Oil is an oil-based treatment designed to remove debris and contaminants in the gearbox and driveline system.

APPLICATION

Suitable for flushing manual gearboxes, automatic gearboxes (ATF systems), differentials, transfer cases & power steering systems.

Applicable in both petrol and diesel passenger car and light commercial vehicles (including hybrids).

Directions for use

1 x 500ml bottle treats up to 12 litres of oil.

• Shake contents of bottle before use.
• Add the full content of the bottle to the oil in the gearbox, differential, transfer case or power steering system.
• Once added, drive the vehicle for at least 15 minutes then drain the oil and refill with new oil.

USER BENEFITS:

• Driveline system will be clean and contaminant free
• Lower contaminants carry over from the previous fluid to the new fluid, which will enhance the protection from the fluid
• Improves the efficiency of the driveline system, therefore increasing the fuel economy of the vehicle
• An oil-based treatment that is not aggressive to different materials and seal types, unlike solvent based flushing products

TYPICAL CHARACTERISTICS for Millers Driveline Flushing Oil:

Density @ 15°C, g/ml … 0.880
Kinematic Viscosity @ 40°C … 11.0cSt
Pour Point °C … -36
Flashpoint °C … >140

PRODUCT SIZES

This product is supplied in the following sizes:  500ml.

FURTHER INFORMATION

For further information, please see our full range of products available from our online shop.

HEALTH AND SAFETY for Millers Engine Flush

Health and Safety Data Sheet 8366 applies to Millers Driveline Flushing Oil. When used for the purpose recommended and with due regard to the appropriate Health and Safety Data, the product should cause no concern. If in doubt, consult with Millers Oils Technical Department.